|Safety protection system:||1 phase and reverse phase protection and indicator light
2 reverse protection and indicator light
3 heat pipe overload protection
4 media buzzer alarm protection and indicator light
5 load protection and indicator light
6 ultra high temperature protection and temperature control device
7 oil protection and reserved interface
8 moving back to the oil unit and set aside the interface, when the mold is clean and not waste
9 type design, operation and maintenance of absolute safety
10 road design, operation and maintenance of absolute safety
1 before molding, TMC automatically control the mold temperature, quickly reach the required temperature and always keep the constant temperature, reducing the time required to preheat the mold.
2 the continuous operation without mold temperature is too high, and on the way down and not due to the mold temperature is reduced and need to wait for heating up, so can improve the production efficiency.
1 plastic physical properties of expansion and contraction, so if the
mold temperature is not stable or improper control, will produce molded clip wave, shrink,Distortions, deformation and poor surface gloss and other phenomena, and the use of TMC models can solve such problems.
2 can make the mold to maintain appropriate temperature, significantly reduce the number of test mode and reduce the defective rate, to ensure product quality.
1, according to the need for any choice of water or heat oil as the heat transfer medium.
2, choose the PID intelligent automatic calculation of the temperature controller, can accurately display and control the temperature of the mold temperature of 1 degrees Celsius.
3, two section type heating structure design, can be regarded as the temperature increase or decrease in power, and with the special heating structure, can save time and energy saving.
1 plastics, rubber industry
2 footwear industry
3 electroplating industry
4 electronics manufacturing industry
5 chemical industry
6 mechanical processing industry
规划表 Specification Bảng thông số:
Phạm vi nhiệt độ (° C)
|Water (Nước) :35℃–120℃|
Dung tích (L)
Công suất bơm (HP)
Áp suất bơm (kg / cm2)
Công suất điện (KW)
Phương pháp làm mát
|Làm mát trực tiếp|
Nhập và xuất khuôn (PT)
Đầu vào và đầu ra làm mát (PT)
Trọng lượng (kg)